Two Unipolar Stepper Driver-Parallel Port (Assembled)
(0 review)

Skill Level : Assembled and Tested

Buy 10, Get 5% Off!
Buy 100, Get 10% Off!


46.94 46.94 USD 46.94


Not Available For Sale

This combination does not exist.

Add to cart

Description: Connects to the PC parallel port and will drive two stepper motors up to max. 3A each. All contained in an RS232, extended D-shell case. Software will accept 4 inputs from external switches. Software will also single step motors. Three run modes supported. All are supplied except the stepper motors. The kit itself does not require any power source. The stepper motors require power. A DOS based program written specifically to drive stepper motors is included on disk, complete with C source code. (CPS113)

NOTE: Please allow 24 hours for assembly! (K113)

Documentation and Downloads