1W Stereo Amplifier Module (Kit)
Buy 10, Get 5% Off!
Buy 100, Get 10% Off!
Description: Uses 2 LM386N-1 for a stereo amplifier. Ideal for walkman and other battery powered items. 4V - 12V DC. Instructions PCB and components supplied. This is a 1 watt per channel, stereo amplifier module Kit using two LM386N IC’s from National Semiconductor. It is basically two of our CPS17’s on a single PC board, with a dual gang pot. It will operate best from 6-12V DC and will work well from a battery since the quiescent current drain is only 10 mA. It requires no heat sinks for normal use. The input and output are both ground referenced. Maximum output will be obtained with a 12V power supply and 8 ohm speaker, however it is particularly suitable for driving headphones from a supply as low as 4V. Speakers are not supplied. They should be rated at 3W or over.
D.C. input : 4 to 12 V at 200 to 500 mA
Max. Idle current : ~ 10 mA
Power output : > 1 Watt max. @ 8 ohms, 12V DC
~ 0.4 Watt RMS cont. per channel
Freq. Resp. : ~ 40 Hz to 100 kHz, 8 ohm
Sensitivity : > 100 mV, G=20
>10 mV, G=200
Input Z : ~ 10 k ohm
PCB size 63mm x 40mm (2.5" x 1.5")
Once the user has seen at least one product this snippet will be visible.
Recently Viewed Products
Documentation and Downloads