10 Buttons Triggered MP3 Player Board with 3W Amplifier and Solder Pads
Buy 10, Get 5% Off!
Buy 100, Get 10% Off!
WeightMajor: 0
WeightMinor: 2
Also available with pin connector. Click here
Features:
With high quality audio decoder, supports MP3 and WAV audio formats.
Works with most Windows, Mac, and Linux systems
Sampling rates supported: 8/11.025/12/16/22.05/24/32/44.1/48(KHz).
24 bit DAC output and supports dynamic range 90 dB and SNR 85dB.
Supports one-on-one 10 button trigger control mode and RS232 serial port control mode.
In button control mode, it plays back 10 sounds one-on-one by negative triggering.
Supports multiple messages per button
Uses a built-in 8 MBytes(64 Mbits) SPI flash memory for storage device
Load audio files to the flash memory directly via the micro USB connecting with computer like using a USB flash drive.
Equipped with a mono 3 watts amplifier that can drive a 1-3 watts (4-8 ohms) speaker directly
Equipped with a 3.5mm audio jack for stereo output that can drive an earphone directly or connect with an external amplifier.
Supports detection of indication signal of status change through the Busy output.
Adjustable sound volume with the potentiometer.
DC 5V power input. Also possible to supply the power via the micro USB port.
PCB size: 40mmx40mm
Technical Parameters:
Working voltage: DC 5V
Working current: ≤250mA
Power Consumption: ≤3W
On-board flash memory size: 8 MBytes(64 Mbps)
Audio format: MP3 and WAV
Make this module motion activated: External PIR Motion Sensor
