Two LED Flasher

Shopping Cart

	Your Cart is Empty
	View Cart

Two LED Flasher

(K138)

Two LED Flasher (CPS138)

Quantity	Price
1 – 9	$7.98
10 – 99	$7.56
100 +	$6.93

Skill Level of Item:		(Kit - Basic Soldering Required)
Product #		CPS138
Quantity Available:		8

Tell a Friend

You might also consider these items:

40 pin Univ ZIF Socket wide slot

Solder directly to PCB or plug directly into IC socket.
Screw mounting holes for more reliable operation.
(BB007)

Quantity	Price
1 – 9	$12.95
10 – 99	$11.95
100 +	$10.95

Skill Level of Item:		(Component or Part)
Product #		BB007
Quantity Available:		15

(Not Pictured)

20 pin ZIF Socket

(BB082)

Quantity	Price
1 – 9	$11.17
10 – 99	$10.58
100 +	$9.70

Skill Level of Item:		(Component or Part)
Product #		BB082
Quantity Available:		15

16 Char x 2 line LCD display (no backlight)

16 Character x 2 line LCD display (no backlight) (BB033)

Quantity	Price
1 – 9	$9.99
10 – 99	$8.95
100 – 999	$7.95
1000 +	$7.45

Skill Level of Item:		(Component or Part)
Product #		BB033
Quantity Available:		15

(Not Pictured)

DS1820 TO92 IC

The DS18S20 Digital Thermometer provides 9–bit temperature readings which indicate the temperature of the device. Information is sent to/from the DS18S20 over a 1–Wire interface, so that only one wire (and ground) needs to be connected from a central microprocessor to a DS18S20. Power for reading, writing, and performing temperature conversions can be derived from the data line itself with no need for an external power source. Because each DS18S20 contains a unique silicon serial number, multiple DS18S20s can exist on the same 1–Wire bus. This allows for placing temperature sensors in many different places. Applications
where this feature is useful include HVAC environmental controls, sensing temperatures inside buildings, equipment or machinery, and process monitoring and control.
GND
DQ
VDD
(BB042)

Quantity	Price
1 – 9	$8.99
10 – 99	$8.45
100 +	$7.99

Skill Level of Item:		(Component or Part)
Product #		BB042
Quantity Available:		8

firmware k148 (T2) - Stopwatch with Pause

Another in the series of timer kits based on the K148 hardware platform. This is a classic stopwatch timer with a pause feature as well. Timing is in hours, minutes, seconds and hundredths of a second up to a maximum of ‘99:59:59.99’. An output signal which pulses low every minute is also available. Please note this item requires the CPS148 to work. This is only the firmware chip for CPS148.
(BB073)

Quantity	Price
1 – 9	$10.45
10 – 99	$9.90
100 +	$8.95

Skill Level of Item:		(Component or Part)
Product #		BB073
Quantity Available:		8

AT24C128 Serial EEPROM 16K

(BB078)

Quantity	Price
1 – 9	$3.95
10 – 99	$3.45
100 +	$3.15

Skill Level of Item:		(Component or Part)
Product #		BB078
Quantity Available:		19

Serial Isolated I/O Module (Assembled & Tested) (Out of Stock)

8-Relay Module (mains rated - 110V and 250VAC.) An extension of our Kit CPS74, PC controlled 8-Relay Board with 250V switching relays and added features. It is in a plastic case, latched relay operation, 250V relays switched in safety by using Dinkle connectors, and with 4 external inputs. Uses serial port so it can be located over 100 yards from the PC. After programming PC can be disconnected. Comes with case and end panel pieces as shown in the photos. Requires a center positive 9-to-12V DC power supply, at least 500mA, 2.5mm jack. (CPA108)

Quantity	Price
1 – 9	$84.95
10 – 99	$79.95
100 +	$74.95

Skill Level of Item:		(Assembled and Tested)
Product #		CPA108
Quantity Available:		0

USB PIC Programmer (Assembled) (Zif socket included)

This programmer connects to a USB port. On board 'B' USB connector. Free software. A wide-slot 40 pin ZIF socket is included with this assembled version. Power supply: at least 16VDC (18VDC preferred) center positive required (power supply jack 5.5mm OD 2.5mm ID) at least 200mA. See this page for which devices can be programmed. (CPA150)

Quantity	Price
1 – 9	$77.52
10 – 99	$72.00
100 +	$69.60

Skill Level of Item:		(Assembled and Tested)
Product #		CPA150
Quantity Available:		13

Rolling Code 4-Channel UHF Remote (partially assembled)

State of the Art, with 4 channels either momentary or latching. Range up to 100'. Up to 15 transmitters can be learned by one receiver. (Includes 1 transmitter) 2 indicator LED's. PCB size: 3 3/8" x 3 1/16" 12VDC 6mA (at rest)(CPA180)

PLEASE NOTE: This is a partially assembled product. The daughter board must still be soldered onto the mother board. 13 solder points. Estimated time to finish: 5 minutes.

Quantity	Price
1 – 9	$70.74
10 – 99	$65.70
100 +	$63.51

Skill Level of Item:		(Partially Assembled)
Product #		CPA180
Quantity Available:		13