Your Cart is Empty
View Cart
 
 
120 Second Non-Volatile Multi Message Recorder KitCPS189
Product Number: CPS189
Click image to enlarge
Description: Non-volatile multi message recorder using ISD chips. Just change one resistor for longer duration. Standalone operation using just six onboard bottons. Record via built-in microphone or external line in. Speaker and line out connector. SPI interface. SPI mode allows full control of the chip via the serial interface. This includes random access to any location inside the memory array by specifying the start and end address. SPI mode also allows access to an internal register for configuration of audio paths, inputs, outputs and mixing.
8-24 VDC. PCB Dimensions: 2.75" x 2"

Please Note: Speaker not included.

Product #: CPS189

Skill Level: Kit - Basic Soldering Required

Additional Details:

Documentation and Downloads:

Leave a Comment or Ask a Question:

Quantity:  

3  
in stock and available for immediate shipment.

 
Click here for more details
120 Second Non-Volatile Multi Message Recorder Kit (Assembled)
Click here for detailed specs.
Description: Non-volatile multi message recorder using ISD chips. Just change one resistor for longer duration. Standalone operation using just six onboard bottons. Record via built-in microphone or external line in. Speaker and line out connector. SPI interface. SPI mode allows full control of the chip via the serial interface. This includes random access to any location inside the memory array by specifying the start and end address. SPI mode also allows access to an internal register for configuration of audio paths, inputs, outputs and mixing. 8-24 VDC. PCB Dimensions: 2.75" x 2"

Please Note:
Speaker not included.

NOTE: Please allow 24 hours for assembly!
Read More
  Assembled and Tested  
  CPS189-TBA  
  3  
Quantity:  

20 Second Voice Recorder/Playback Module (A93010)
tn_a96010_general.png
PLEASE NOTE: This module, part# A96010, is actually an A93010. It is virtually identical to the A96010 and it operates the same, but downloadable datasheets are available for each for comparison if necessary. The small size is because the IC is in Chip-on-board form. One button is pushed down to record the message through the on-board electret microphone; A LED turns on during this time. The other button just has to be momentarily pressed to replay the message. A second momentary press during playback will stop the playback. Sampling rate is 4K. All you have to add is the speaker (not included) and 5V DC power (not included). We also have an A96010-kit which in addition to the part# A96010 also includes a speaker and two cable connectors to connect the unit to a power supply (not included) and the speaker. The record/play time is determined by the 52K resistor. If you change it to 89K you will get 30 seconds but at a reduced sampling rate. Operating current 25mA. Standby current 10 uA. Size: 34 x 23 x 11 mm. The module comes supplied as you see it in the photo. 

OPTIONAL ITEMS (Not included):
  • 2 x (BB089) connector cable to connect the voice recorder to a speaker and power source.
  • 1 x (PB244) Speaker
  • 1 x Battery holder that can hold either 4 x AAA or 4 x AA or 4 x C or 4 x D cells. See our battery holders.
Read More
  Assembled and Tested  
  A96010  
  38  
Quantity:  

A96010 Kit (A96010 with Wires and Speaker Included)
tn_a96010-kit_general.png
PLEASE NOTE: This module, part # A96010, is actually an A93010. It is virtually identical to the A96010 and it operates the same, but downloadable datasheets are available for each for comparison if necessary. The small size is because the IC is in Chip-on-board form. One button is pushed down to record the message through the on-board electret microphone; A LED turns on during this time. The other button just has to be momentarily pressed to replay the message. A second momentary press during playback will stop the playback. Sampling rate is 4K. All you have to add is the speaker (not included) and 5V DC power (not included). We also have an A96010-kit which in addition to the part# A96010 also includes a speaker and two cable connectors to connect the unit to a power supply (not included) and the speaker. The record/play time is determined by the 52K resistor. If you change it to 89K you will get 30 seconds but at a reduced sampling rate. Operating current 25mA. Standby current 10 uA. Size: 34 x 23 x 11 mm. The module comes supplied as you see it in the photo.

This is a kit which includes the following items:
  • 1 x A96010 voice recording module (20 second message)
  • 2 x Connector cable to connect the voice recorder to a speaker and power source.
  • 1 x 1watt 3inch 8ohm Speaker
  • (You will need to connect the connector cables to the speaker and a power supply preferably by soldering)

Not included:
  • 1 x Battery holder that can hold either 4 x AAA or 4 x AA or 4 x C or 4 x D cells. See our battery holders.
Read More
  Partially Assembled  
  A96010-kit  
  38  
Quantity:  

Voice Recording Module 2 x 20sec Sections
Click here for detailed specs.
CLOSEOUT ITEM - WHILE STOCK LASTS.

Description: The A96020 voice recording module offers true single chip solid state storage capability and requires no software or micro-controller support. It provides high quality recording and playback with dual 20 second message. Sampling rate is 3.2K. Size: 34 x 23 x 11 mm. All you need to do is add a speaker (not included) and 5V DC Power (not included).

Features:
  • Non volatile flash memory technology
  • No battery back up required
  • User friendly, easy to operate
  • Slide switch for record or play back
  • Separate key to trigger message 1 or 2
  • Low power consumption
  • LED to indicate recording and playback
  • Built-in condenser mic
  • Automatic power down
  • 5-6V Operation.

OPTIONAL ITEMS (Not included):

  • 2 x (BB089) connector cable to connect the voice recorder to a speaker and power source.
  • 1 x (PB244) Speaker
  • 1 x Battery holder that can hold either 4 x AAA or 4 x AA or 4 x C or 4 x D cells. See our battery holders.
Read More
  Assembled and Tested  
  A96020  
  2  
Quantity:  

A96020 Kit (A96020 with wires and speaker included)
Click here for detailed specs.
CLOSEOUT ITEM - WHILE STOCK LASTS.

Description:
The A96020 voice recording module offers true single chip solid state storage capability and requires no software or micro-controller support. It provides high quality recording and playback with dual 20 second message. Sampling rate is 3.2K. Size: 34 x 23 x 11 mm. All you need to do is add a 5V DC Power supply (not included).

Features:
  • Non volatile flash memory technology
  • No battery back up required
  • User friendly, easy to operate
  • Slide switch for record or play back
  • Separate key to trigger message 1 or 2
  • Low power consumption
  • LED to indicate recording and playback
  • Built-in condenser mic
  • Automatic power down
  • 5-6V Operation.
Not Included:
  • 1 x Battery holder that can hold either 4 x AAA or 4 x AA or 4 x C or 4 x D
    cells. See our battery holders.
Read More
  Partially Assembled  
  A96020-kit  
  2  
Quantity:  

ISD17120 ChipCorder
Click here for specs, downloads and more pictures.
 (Out of Stock)The specific model you are buying: ISD17120

The Winbond® ISD1700 ChipCorder® Series is a high quality, fully integrated, single-chip multimessage
voice record and playback device ideally suited to a variety of electronic systems. The
message duration is user selectable in ranges from 26 seconds to 120 seconds, depending on the
specific device. The sampling frequency of each device can also be adjusted from 4 kHz to 12 kHz
with an external resistor, giving the user greater flexibility in duration versus recording quality for each
application. Operating voltage spans a range from 2.4 V to 5.5 V to ensure that the ISD1700 devices
are optimized for a wide range of battery or line-powered applications.
Read More
  Component or Part  
  BB266  
  0  
Quantity:  

ISD1740 ChipCorder
Click here for specs, downloads and more pictures.
The specific model you are buying: ISD1740

The Winbond® ISD1700 ChipCorder® Series is a high quality, fully integrated, single-chip multimessage
voice record and playback device ideally suited to a variety of electronic systems. The
message duration is user selectable in ranges from 26 seconds to 120 seconds, depending on the
specific device. The sampling frequency of each device can also be adjusted from 4 kHz to 12 kHz
with an external resistor, giving the user greater flexibility in duration versus recording quality for each
application. Operating voltage spans a range from 2.4 V to 5.5 V to ensure that the ISD1700 devices
are optimized for a wide range of battery or line-powered applications.
Read More
  Component or Part  
  BB286  
  4  
Quantity:  

PCB of the CPS188/CPS189 K188/K189 ONLY
Click here for specs, downloads and more pictures.
PLEASE NOTE: This is the unpopulated PCB of the CPS188/CPS189  K188/K189 only. 

Dimensions: 2.75" x 2"
Read More
  Component or Part  
  BB292  
  4  
Quantity:  

5 minute sound recording module. 5 separate messages. speaker, microphone & switches included.
Click here for detailed specs.
 (Out of Stock)THIS ITEM (BD43) NOT CURRENTLY AVAILABLE FOR SALE.
Price was: $19.94

Record and playback a total of up to 5 minutes! Up to 5 separate messages can be recorded and play back with 5 separate push switches. The 5 segments share a total of 5 minutes. Microphone, speaker and push switches included. 

Specifications:
  • PCB size: 1.9" x 1.6"
  • Wire length of push switches: approx 3.5"
  • Requires 4 x AAA batteries (not included).
Read More
  Assembled and Tested  
  BD43  
  0  
5 Minutes Recording Module - Separated in 5 Segments - Module ONLY
Click here for detailed specs.
CLOSEOUT ITEM - LOWER PRICE, WHILE STOCK LASTS.
Price was: $15.99

PLEASE NOTE: This is just the module. Doesn't include the microphone, speaker battery box etc., that plugs into this module.

Record and playback a total of up to 5 minutes! Up to 5 separate messages can be recorded and played back. The 5 segments share a total of 5 minutes.

Specifications:
  • PCB size: 1.9" x 1.6"
  • 6V DC
For the module including the microphone, speaker battery box and switches see product #BD43
Read More
  Assembled and Tested  
  BD43PCB  
  119  
Quantity:  

20 Second recording module with 9V battery Connector
Click here for specs, downloads, and more pictures.
Fully Assembled and tested. All you need to do is add a 9V Battery.

Record:
Press and hold “Record” switch. LED indicator turns on and start recording. Release switch to finish recording, and LED turns off.
Play: Press “Play” switch to play complete message once.

Specifications:
  • 20 second non-volatile recordable IC.
  • Includes Electret microphone for recording.
  • 40mm Mylar speaker included.
  • Operating Voltage: 9V (battery not included)
  • Operating Current: <= 40mA (average)
  • Standby Current <= 0.2mA
  • PCB size: 1.8" x 1" (45mm x 25mm)
Read More
  Assembled and Tested  
  BR9  
  207  
Quantity:  

40 Second Non-Volatile Multi Message Recorder Kit
Click here for detailed specs.
 (Out of Stock)
Description: Non-volatile multi message recorder using ISD chips. Just change one resistor for longer duration. Standalone operation using just six onboard bottons. Record via built-in microphone or external line in. Speaker and line out connector. SPI interface. SPI mode allows full control of the chip via the serial interface. This includes random access to any location inside the memory array by specifying the start and end address. SPI mode also allows access to an internal register for configuration of audio paths, inputs, outputs and mixing. 

8-24 VDC. PCB Dimensions: 2.75" x 2"

Please Note:
Speaker not included.
Read More
  Kit - Basic Soldering Required  
  CPS188  
  0  
Quantity:  

Recording Module 20 Second - Card Type
Click here for specs, downloads, and more pictures.
Description: 20 second card type recording unit. This module can be pasted (self-adhesive backing) into birthday cards, Christmas cards etc. When the card is opened your message will be played. You can record your own custom 20 second message with the built in microphone. The module is pre wired with a speaker and battery. All that is left for you to do is to record a message, past the module in your card and remove the little plastic tubing from the metal strip that protects the battery from running down when shipped from the factory.

Product Information:
  • Description: 20 second recording card module
  • Size:Length : 105mm, Width : 65mm, Height: 6.4mm(4.1"x 2.6" x 0.25")
  • Accessories: Battery Insulator, Battery G10 3pcs, Speaker 40mm (1.6")
  • Function: Record & Play back
  • Operation: Record : Press switch. Play back : Open the card.
  • Length of record: 20 seconds
Read More
  Assembled and Tested  
  CT94R  
  168  
Quantity:  

40mm (1.6in) Metal Housing Mylar Speaker 0.25W
Click here for specs, downloads and more pictures.
Specifications:
  • 0.25W
  • 40mm (1.57in)
  • 16 Ohm
Read More
  Component or Part  
  PB240  
  217  
Quantity:  

Speaker Round 3 inch 8 ohm 1 watt
tn_pb244_general.png
Specifications:
  • Diameter: 76mm (3 inch)
  • 1 Watt
  • 8 Ohm
Read More
  Component or Part  
  PB244  
  115  
Quantity:  

Speaker Round 3 inch 8 ohm 1 watt
tn_pb244_general.png
Specifications:
  • Diameter: 76mm (3 inch)
  • 1 Watt
  • 8 Ohm
Read More
Quantity: